Custom Bats Cricket Forum
Equipment => Bats => Bat Care => Topic started by: Joe on November 16, 2011, 06:31:30 PM
-
I'm currently refurbing a Puma Atomic 4000 so I can use it as a net bat, then encountered a problem. Apart from the usual Puma stickers, it had a hammer edge sheet that's been on for about 3 years. After battling to take it off (the right way) it removed a lot of wood with it. In some places there is about 3mm taken out. So what do I do. My instinct is just to sand it to within an inch of it's life, but is this the best option? I'll try and get pics up later.
-
This happened on a Dukes I had I just sanded, a bit of wood filler, light sand and then a scuff sheet
still going strong and no deteriation around the filler