Custom Bats Cricket Forum
Equipment => Bats => Bat Making => Topic started by: Banksy on August 07, 2013, 02:00:29 PM
-
Pretty much as the title. I've 300 grit for the drum sander but do I need to go down another level for the final bit of hand sanding? I got some 'ultra fine' foam sanding blocks and they buff the bats up a treat, god knows what grade they are though...
-
I work through about 6 grades ending up on about 2000 grit. Don't know if there's much point going that low but it produces a beautiful smooth and shiny finish.
-
I go up to about 800 grit. Used to go to 1200, but felt that it was overkill.
-
Cheers.
I've got 120, 240 and 300 on the sander, so might get some 400 & 500 for hand sanding then.
Or do you think I should go another grade on the drum sander, say 400, and finish with 600 & 800 by hand?
-
There is not a huge difference in finish above 600 especially if you are planning to use wax to buff it up.
-
Cheers.
I've got 120, 240 and 300 on the sander, so might get some 400 & 500 for hand sanding then.
Or do you think I should go another grade on the drum sander, say 400, and finish with 600 & 800 by hand?
I have a black and decker Orbital sander, and go 40, 80, 120, 180, 240, 320, 400 and sometimes 600 and 800, depending on how the bat looks/feels
-
I have a black and decker Orbital sander, and go 40, 80, 120, 180, 240, 320, 400 and sometimes 600 and 800, depending on how the bat looks/feels
40? Wow that's low. I'm not sure about anyone else but the lowest I go is around 120-150. End up around 500. As long as you take your time on each one you shouldn't need to go to low or too high
-
A mate of mine is a veneerer and he said he didn't see the point in going higher than 320 grit. In his own words you are going "below cellular level". A light wax & buff finish is what you want after that IMO.
-
I start with 80 and finish with a 400......as you can see from all the responses it's different for each person as people use different brands/quality of paper and finish differently.....I'd recommend trial and error to see what works for you
-
Oakley 'Between coats' sandpaper is the best paper I have found for hand sanding. Really shifts the wood and doesn't clog too easily and can be tapped out quite easily if you know what I mean. Bit pricey though :s
-
It all depends on the quality and type of sandpaper used.
-
It all depends on the quality and type of sandpaper used.
this is very very true!
i had some cheap 600 gritt sand paper that i was finishing bats off when i was referbing stuff..
but the stuff ryan uses gets that sort of finish with 150 grit!
-
I tend to finish of using 'wet & dry' paper seems to get a better finish
can go as far as 1200 grit
http://www.screwfix.com/p/titan-wet-dry-sanding-paper-230-x-280mm-600-grit-pack-of-10/95130 (http://www.screwfix.com/p/titan-wet-dry-sanding-paper-230-x-280mm-600-grit-pack-of-10/95130)