Topic: Shoulder work (Read 3181 times)

Grubby · « **on:** April 21, 2021, 07:30:40 AM »

A question to the bat makers. How do you personally cut the shoulders down to the marks on the attached?

Thanks.

LEACHY48 · « **Reply #1 on:** April 21, 2021, 07:41:49 AM »

Spindle moulder is the best way.

Bandsaw will do if you�re accurate, coping saw will be good if you can use it properly.

edge · « **Reply #2 on:** April 21, 2021, 08:04:33 AM »

For the home podshaver a jigsaw does the job pretty well.

e4sby · « **Reply #3 on:** April 21, 2021, 08:32:06 AM »

Coping saw is the way to go

Vulcan Cricket · « **Reply #4 on:** April 21, 2021, 09:46:32 AM »

Draw knife up side down

SOULMAN1012 · « **Reply #5 on:** April 21, 2021, 01:06:13 PM »

As Dean says Drawknife upside down, then a Curved spokeshave and then Sand

Northern monkey · « **Reply #6 on:** April 21, 2021, 05:11:43 PM »

Jigsaw,,two minute job

Northern monkey · « **Reply #7 on:** April 22, 2021, 08:11:20 AM »

Northern monkey · « **Reply #8 on:** April 22, 2021, 08:12:06 AM »

Grubby · « **Reply #9 on:** April 22, 2021, 08:57:46 AM »

Thank You All.

JB · « **Reply #10 on:** April 22, 2021, 12:09:43 PM »

Serious freehand skills