Advertise on CBF

Author Topic: Handle jig advise  (Read 2611 times)

0 Members and 1 Guest are viewing this topic.

Guyfawkes

  • Village Cricketer
  • *
  • Offline Offline
  • Posts: 15
  • Trade Count: (0)
Handle jig advise
« on: March 03, 2021, 03:16:59 PM »
Afternoon all,
I have had a bandsaw delivered today so need to get onto getting a jig together for rehandled. Any advise on the best way to go about it?
Any advise great fully received
Logged

LEACHY48

  • International Captain
  • ****
  • Offline Offline
  • Posts: 2278
  • Trade Count: (+4)
Re: Handle jig advise
« Reply #1 on: March 17, 2021, 09:07:42 PM »
Best thing you can do is a sheet of MDF with a frame that holds the bat and a bolt through the middle of the frame and the base plate of MDF.

Then have 2 bolts either side of the frame, so it can only move a certain amount in each direction.

Then, the handle has to be an exact mirror of this cut using the same method as above, allowing for the fact you lose 1mm for the cut.
Logged

Gurujames

  • International Captain
  • ****
  • Offline Offline
  • Posts: 1663
  • Trade Count: (0)
Re: Handle jig advise
« Reply #2 on: March 17, 2021, 10:18:55 PM »
Tip - use an off it of old blade as a spacer to account for the (kerf) thickness of the cut.
Logged
 

Advertise on CBF