Advertise on CBF

Author Topic: Taping an oiled bat  (Read 1009 times)

0 Members and 1 Guest are viewing this topic.

Milky Bar Kid

  • Club Cricketer
  • **
  • Offline Offline
  • Posts: 135
  • Trade Count: (0)
Taping an oiled bat
« on: May 02, 2012, 10:43:01 AM »
Just sorting out a wet weather bat for this weekend (don't wanna ruin the scoop!). I've sanded it all down. Glued some small cracks and oiled it. How long would you say to wait til fibreglass tape will stick properly to the blade? In the past it's just fallen off. The bat was oiled last Thursday if that helps.

Cheers

Milky
Logged

Red Ink Cricket

  • Forum Sponsor
  • World Cup Winner
  • *****
  • Offline Offline
  • Posts: 3293
  • Trade Count: (+8)
  • Red Ink Cricket
    • Red Ink Cricket
Re: Taping an oiled bat
« Reply #1 on: May 02, 2012, 10:44:33 AM »
should be fine after 24 hours. you can always give the areas your putting the tape on a very light sand to help make it stick. can always touch those areas in afterwards with oil when the tape has stuck properly
Logged
www.redinkcricket.co.uk
John@redinkcricket.co.uk
@red_inker

wilkie113

  • World Cup Winner
  • *****
  • Offline Offline
  • Posts: 4452
  • Trade Count: (+29)
Re: Taping an oiled bat
« Reply #2 on: May 02, 2012, 10:45:30 AM »
Try a little bit of tape and see if it sticks, and if it does take the little piece off and then put the tape where you want to :)
Logged

Milky Bar Kid

  • Club Cricketer
  • **
  • Offline Offline
  • Posts: 135
  • Trade Count: (0)
Re: Taping an oiled bat
« Reply #3 on: May 02, 2012, 10:45:51 AM »
Thanks, I'll try it now and see how it goes
Logged

Milky Bar Kid

  • Club Cricketer
  • **
  • Offline Offline
  • Posts: 135
  • Trade Count: (0)
Re: Taping an oiled bat
« Reply #4 on: May 02, 2012, 11:03:21 AM »
Had to use a really fine sanding block on the edges but other than that it was fine. Thanks.
Logged
 

Advertise on CBF