Topic: 60 minute makeover (Read 1663 times)

uknsaunders · « **on:** October 25, 2011, 04:41:02 PM »

Picked up a used Raje bat which was looking at bit worse for wear. Got bags of potential, G1/2 material but just a bit tired. Here are the before pics:-

An hour later:-

Ayrtek Cricket · « **Reply #1 on:** October 25, 2011, 04:53:27 PM »

good work mate....amazing what a quick sand will do to a bat!

uknsaunders · « **Reply #2 on:** October 25, 2011, 05:03:09 PM »

yes, 80 grit sanding paper and a sander got the worst off in about 10 minutes. Rest of the time was spent doing the tricky curvy bits on the back by hand. A bit of wire wool for fine sanding and it's done. The bat in it's original condition was a bit unfinished and either not sanded down or some diy sanding had gone on. Tempted to stick some Linseed or Beeswax on to finish off, but it looks pretty good as it is. Might get some raje stickers and scuff and slap it on ebay. It's 2'8 btw with a pretty thick handle and 1 grip.

FattusCattus · « **Reply #3 on:** October 25, 2011, 08:08:58 PM »

Where d'ya pick it up from?

uknsaunders · « **Reply #4 on:** October 25, 2011, 10:22:51 PM »

ebay of course

very surprised nobody else picked up on it. The seller made a complete hash of selling it by only showing the side profile and giving the bare minimum of detail. Lucky for me I spotted the "raje" on the side and realised it was probably a decent stick, unlike the rest of fleabay. A few emails with the seller to get a view of the face and establish the history of the bat confirmed my initial thoughts. Bat was brought for �170 new and used for a season according to the seller, with no real damage to the face during that time.

uknsaunders · « **Reply #5 on:** October 26, 2011, 06:12:03 PM »

thinking about turning it into a laminate, reckon it's possible?

Joe · « **Reply #6 on:** October 26, 2011, 06:23:17 PM »

why not! I assume you would do it by sawing (presumably with an electric bench saw) a thin layer of wood off the face of the bat and then glueing it back on. Or you could just glue a chunk of wood to the front of it.

Or

How about a double laminate? Or even triple! Two or three pieces of wood glued to it - double/triple the rebound, surely.

uknsaunders · « **Reply #7 on:** October 26, 2011, 06:29:33 PM »

Quote from: JoeHig on October 26, 2011, 06:23:17 PM

why not! I assume you would do it by sawing (presumably with an electric bench saw) a thin layer of wood off the face of the bat and then glueing it back on. Or you could just glue a chunk of wood to the front of it.

Or

How about a double laminate? Or even triple! Two or three pieces of wood glued to it - double/triple the rebound, surely.

love to try something, just out of my skill range

. Any batmakers fancy a crack?

Author Topic: 60 minute makeover (Read 1663 times)

uknsaunders

60 minute makeover

Ayrtek Cricket

Re: 60 minute makeover

uknsaunders

Re: 60 minute makeover

FattusCattus

Re: 60 minute makeover

uknsaunders

Re: 60 minute makeover

uknsaunders

Re: 60 minute makeover

Joe

Re: 60 minute makeover

uknsaunders

Re: 60 minute makeover