Print

[kk0239]

Im in the knocking process.. i removed the stikers today and realised that tgere is a crack on the back of tge handle.. but the thing is the front of the splice looks clean..
how can i address this issue?
Is it bad?




Sent from my SAMSUNG-SGH-I337 using Tapatalk

[tejasapatel]

I am no expert but I would try putting some watered down glue there just like I would on any other crack. If that doesn't hold or feel good I am sure you can buy a handle from one of the forum sponsors and attach it.

Finally there is an option of sending it to a professional from the forum.

[e4sby]

That isn't a crack just a handle that hasn't been fitted perfectly. Probably won't go anywhere and have seen worse examples than this that didn't budge.

If there is a gap for some glue no harm filling it for peace of mind.

[WalkingWicket37]

It'll be fine, you could put some glue in if you want peace of mind though.

Out of interest why did you remove the stickers??

[Seniorplayer]

IMO that's a gap between handle and splice not a crack, is the handle flush with the blade at the front and back. Also you can fill the gap with PVA glue.

[yogi206]

yeah that is no crack or split it is just the splice fitting that isn't perfect no issue as there will be plenty holding it in there

[kk0239]

I am no expert but I would try putting some watered down glue there just like I would on any other crack. If that doesn't hold or feel good I am sure you can buy a handle from one of the forum sponsors and attach it.

watered down glue?
And may i how much it would roughly cost me to get a good new handle?

[kk0239]

Out of interest why did you remove the stickers??

Ive got some new MRF stickers.. will slap them on bat once i get the bat ready

[Bruce]

A rehandle may affect the whole balance of the bat